![]() In this lab, EIGRP will be used as the routing protocol. ![]() Ip address 10.254.1.240 255.255.255.255 1.2 – Configure routing to form a neighbor relationship with hub1, hub2, and edge-1. ! Optionally configure a looback interface 1 – Configure the DS-SW1-HQ 1.1 – Configure the interface connected to hub1, hub2, and edge-1: # ds-sw1-hq # Please refer to our topology to have a better overview of the configurations. ![]() The lab focus solely on how the configuration fits together in deploying the DMVP with a particular design which is the Dual router Hub, dual Internet (DMVPN cloud) and single and dual router remote-site (see figure below).Īs usual, we’re going to use GNS3 and Cisco IOU L2 and 元. In Cisco IWAN Deployment Guide there are a lot of advanced configurations but as for this lab will focus only on base configuration. If you are looking for more detail explanation of all the protocols involved in DMVPN for certification purposes, you can refer to INE Blog – DMVPN Explained and INE Blog – DMVPN Phase 3. Dynamic Routing Protocol (EIGRP, RIP, OSPF, and BGP).Multiple Generic Routing Encapsulation (mGRE).As you may already know, DMVPN is an Overlay technology that runs on any underlay IP transport such Internet, MPLS, and 3G/4G. Hi everyone, today I just would like to share a lab configuration on one of the Cisco IWAN DMVPN design models.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |